1/12th Scale Modified

 

 

Rules

 

 

Chassis

 Any commercially available 1/12 scale rear wheel drive pan car chassis with T-bar or Pivot Ball Link. Independent rear suspension is not allowed. Modelers may build their own chassis following the rules in the “Appendix - Custom Chassis” 

Motor

 Any motor on the approved ROAR list.

ESC

Any 1s ESC on the approved ROAR list.

 A 1s specific ESC is recommended for its plug and play application, a 2s ROAR approved ESC that supports 1s application may be used.

N.B. a voltage booster or separate 6.6v LiFe receiver pack will be required to provide consistent power to the servo and receiver.

            Recommended ESCs:

            Budget: Trackstar GenII One Cell 120A 1/12 scale Sensored Brushless ESC

            Highly recommended: Hobbywing XeRun XR10 Pro 1s

            Recommended voltage booster for use with 2s esc: Hobbywing 1s DC-DC booster

            Recommended receiver battery: Dynamite 6.6v 220mAh LiFe Receiver Pack w/switch

 

*Please only use a LiFe rx battery for safety purposes as they are significantly safer than LiPo batteries if the voltage drops below the safe rating.

Body Shell

Only LM-style body shells on the approved body list provided by IFMAR, EFRA, ROAR or BRCA may be used. Additional side dams may not be fitted. Only side dams moulded into the original body shell are allowed. Body shell may not be trimmed higher than the lower body trim lines - wheel arches must be cut out. No part of the chassis, wheels, tyres, suspension or electrical equipment may be visible outside the body shell when viewed in any plane, except for directly from the rear of the chassis. Rollover antenna may be fitted. If fitted, it must have a blunt end for safety reasons. The antenna must be part of the mast along its length. Maximum height from the ground: 350mm

            Recommended Body Shells:

            Protoform AMR12

            Protoform BMR12

            Protoform BMR12.1 

Wings

Only one rear wing, moulded into the body shell, may be used. An additional gurney flap may be fitted, provided it does not exceed the height of the originally moulded rear wing. No holes or slots are allowed on the body or wing, except for body post, aerial and club rental transponder holes.

Tyres

Only 1/12 scale foam tyres may be used. Pre-mounted or user glued tyres are allowed. Wheel dimension must not be smaller than 29mm and must not exceed 38mm.

Maximum rear tyre width: 40mm

Maximum front tyre width: 28mm 

            Recommended Tyres:

Front

Ulti Medium (Asphalt)

Ulti Hard (Asphalt)

Rear   

Ulti Z Compound (Soft) Rear (highly recommended)

Ulti Extra Soft (XSS) Rear 

            Recommended Traction Compound:

            LG2

            Volante Purple

N.B. While truing is recommended for foam tyres it is not necessary with the new Ulti tyres recommended above as they come pre-trued to the correct diameter for asphalt from the factory. 

Hop-Ups

All hop-ups for 1/12 scale pan cars are allowed. 

Batteries

Any ROAR approved 1s (one cell) Li-Poly hardcase battery is allowed. HV Graphene batteries are allowed however, maximum charged voltage must not exceed 4.22v.

            Recommended budget battery:

            Turnigy Nano-Tech 6800mah 1s 3.7v 

Gearing

Any gearing is allowed. 

Weight

Minimum race-ready weight: 730g (with transponder) 

Dimensions

Overall Min Width: 155mm

Overall Max Width: 176mm

Max Track Width: 172mm

Overall Min Length: 320mm

Overall Max Length: 380mm